$6.00
SHIPPING

Any USA, territory, or military address.
No minimum purchase.


 
Search
JEEP PARTS ONLY
JEEP PARTS ONLY

Shopping Cart
Your cart is empty.



Browse Categories
JEEP Model, Year, and Engine We ONLY SUPPORT those vehicles and engines listed below. Grand Cherokee: No Products

C2572-1, 1" Motor Mount Lift, Classic Polyurethane


Price: $104.95
AVAILABLE
Part Number: C2572-1
Includes: Everything shown plus 1 sticker
Made in USA: Using USA steel, bushings, hardware, etc.
Warranty: Lifetime - Except bushings
C2572-1, Classic Polyurethane 1" Motor Mount Lifts (Pair)  
 
Want Jeep motor mount lifts (MMLs) to help correct driveline angle caused by an extreme suspension lift? Doing a tummy tuck or other modification that's impacting drive-line angle? Brown Dog designed these MML to reposition your engine one inch higher than stock (at the cooling fan). This modification results in a change in the driveline angle. 

 

High Performance Design.
The Brown Dog experienced a sagging engine on his own Wrangler YJ. This is why we engineered these replacement MML for extreme strength. You'll find these mounts a serious upgrade from most others, too. We use plate steel and double-weld joints to provide the most strength possible. And, just to make sure, we periodically pull one off the shelf and put it through our 20-Ton Press Test. We have never seen a structural failure on Brown Dog mounts.
 

Featuring Classic Polyurethane Bushings.

The Classic Polyurethane bushings in this set of Brown Dog motor mounts will give your rig a sportier feel. If the bushings ever start to wear, replacements are available from Brown Dog Offroad. Prefer Ultra-Flex Rubber bushings? We offer all motor mounts and motor mount lifts with either polyurethane or rubber to match your preference. Not sure which is for you? Click here.

 

Backed by Brown Dog Promise.
Brown Dog motor mounts will be the last set of mounts you'll need. The Brown Dog gives you his promise.

 

Installation Notes

  • Engine is lifted 1" at stock cooling fan.
  • Mounts bolt directly to the frame-side pylons, in the same bolt holes as the stock mounts. Bolts to pylons should be tightened like most others on your Jeep frame. Nice and tight.
  • Carefully inspect engine brackets for any excess wear, especially cracks. Also carefully inspect your engine block for sheared bolts and/or broken thread bosses. If engine brackets need replaced or engine block is questionable or you have stroked your engine, please consider upgrading to our S2572-1 Super Kit which includes our 1" MML and Super Engine Brackets (utilizing more engine block bolts than the original brackets) for most 4.0L &  4.2L Jeep vehicles.
  • Tighten through-bolts (bolt that goes through bracket arms and motor mount) exactly according to installation directions. Overtightening these bolts will result in excessive vibration transfer.
  • If installation instructions are followed, there is not a need to remove the alternator nor air conditioner compressor.
  • Designed for use with either Brown Dog or Jeep engine brackets for Wrangler 4.2L or 4.0L originally installed on Jeep YJ. 
  • If you have any questions during installation or believe a part will not fit, do NOT alter the part nor your vehicle. Call Brown Dog, 866 401-3877. We have extended support hours to assist with installation. No question is too simple. We're here to help.

Application Notes

  • Jeep Wrangler YJ, 6-Cylinder, 4.0L, 242ci, 1991, 1992, 1993, 1994, 1995
  • Jeep Wrangler YJ, 6-Cylinder, 4.2L, 258ci, 1987, 1988, 1989, 1990